Texture resin

Description

Instructions for use:

(1) Before use:
Shake the liquid resin before use; Clean the resin tank and moulding platform to maintain the light transmission of the resin tank bottom.

(2) During use:
Unscrew the cap and add it to the resin tank according to the equipment requirements; Select the correct print parameters and settings for printing.

(3) After use:
After printing, please use the appropriate tools for post-processing, including a blade, diagonal pliers, tweezers, containers, gloves; a cleaning solution containing ethanol (≥ 95%), lactate or isopropyl alcohol;

(4) Post-processing steps:
A. Remove the printed model from the moulding platform with a blade;
B. Immerse the model in the cleaning solution, rinse or wash with ultrasound, then remove and drain; ANYCUBlC washing and curing machines are recommended to ensure the best results.
C. Appropriate treatment, such as support removal, polishing, colouring, etc.

(5) Wastewater post-treatment:
A. Do not discharge wastewater directly into the sewer system to avoid contaminating groundwater.
B. Heat the wastewater, allow most of the water to evaporate, then dispose of the residue after hardening it using a hardening machine and sunlight.

Precautions
The ideal condition for storing uncured resin is a cool, dark place at room temperature and away from light to avoid high temperatures or sunlight.
The suggested operating temperature is 18–35°C, and low temperatures may affect the printing effect, so the resin can be properly preheated before use (no more than 60°C).
If the resin pigment settles, it can be used after stirring or shaking. In order to ensure the performance of the resin, please remove the model in time after cleaning to avoid the model soaking in water for a long time.

To ensure the mechanical properties of the model, please perform post-curing in a timely manner after cleaning and drying. To ensure the ideal performance of the curable material, it is necessary to control the intensity and time of the light source after curing.

Therefore, the following steps are recommended:
(1) The intensity of the mercury lamp or LED light source is 5 to 10 mW/m², and the duration does not exceed 1 hour (self-regulating);
(2) Exposure time to the sun (in summer) is approximately 1 hour;
(3) Proximity to or long-term exposure under powerful light sources such as high-pressure, high-power mercury lamps is prohibited;
(4) It is recommended to print in a dark room or cover with a lid during printing as resin is a photosensitive material;
(5) To prevent yellowing caused by long-term curing of High Clear resin, please reduce the exposure time by half compared to other resin colours;
(6) Black resin may appear partially transparent in thin walls (< 0.5 mm), so that the greater thickness can achieve better colour effects.

PS: The properties of the material vary depending on the moulding equipment, post-curing method and testing equipment. For safety information,
please refer to the SDS for this product. If you encounter any problems during use, please do not hesitate to contact us.